Help us help you. By posting the year, make, model and engine near the beginning of your help request, followed by the symptoms (no start, high idle, misfire etc.) Along with any prevalent Diagnostic Trouble Codes, aka DTCs, other forum members will be able to help you get to a solution more quickly and easily!
Network comm questions, 2021 Toyota Tacoma, 3027miles
Front right hit owner bought it at auction with no keys. Asked me to come in and make a Key, proximity push to start type.
I struggle with CAN network testing other than 60ohms sitting idle on the network.
Once I hit the button network jumps all over voltage wise .
I know a scope would be best. My question is if certain wires are exposed, not shorted will this bring down the CAN network and if so if I pull those modules offline will it come back to normal after I disconnect them though they won't have faults as I feel as if with the CAN H & CAN L signals they have to go essentially a circle thru the item and then come back?
I do know there was a 4 or 5 wire harness near the hood latch area that the wires are cut flush, a air bag sensor mushed up a little bit then headlight, clearance wires loose and or broke off from the deer hit.
This vehicle was totaled out from the deer hit. I have my doubts about if it really was a deer or not or maybe something else, inattentiveness or something else maybe.
I'll get the scope out and rough it till I "get it" or learn.
Topic Author
