Help us help you. By posting the year, make, model and engine near the beginning of your help request, followed by the symptoms (no start, high idle, misfire etc.) Along with any prevalent Diagnostic Trouble Codes, aka DTCs, other forum members will be able to help you get to a solution more quickly and easily!

2015 VW Golf Wiper Motor Inop Lin Bus U103000

jcampisi1202
Topic Author
Offline
New Member

5 days 3 hours ago #93147 by jcampisi1202

2015 VW Golf Wiper Motor Inop Lin Bus U103000 was created by jcampisi1202

I have a 2015 VW Golf 1.8L that came in from another shop with a handful of issues. Main concern was the front wiper motor was inop. They had replaced the Wiper motor and linkage, then tore a bunch of stuff apart. After reinstalling original motor and buttoning what I can back up to test, I found that wiper motor Lin Bus is biased at just above 9v. This is with wiper motor plugged in, unplugged, commanded by switch, and scan tool, no change. When unplugging connector T46B from J519, Lin Bus drops to 0V. So at this time I have condemned the “Vehicle Electronics System Module” as it’s called in service data. I don’t work on many European vehicles, so my question is, is there coding, or programming that this module will need following replacement? I found No after repair into in mitchell or control module referenced in All Data. Thanks in advance.

Attachments:

Please Log in or Create an account to join the conversation.

Chad
Offline
Moderator
I am not a parts changer.

4 days 17 hours ago #93153 by Chad

Replied by Chad on topic 2015 VW Golf Wiper Motor Inop Lin Bus U103000

I am, fairly, certain that the module will have to be programmed. However, I have no experience with VW, and cannot offer any help.

"Knowledge is a weapon. Arm yourself, well, before going to do battle."
"Understanding a question is half an answer."
I have learned more by being wrong, than I have by being right.

Please Log in or Create an account to join the conversation.

Time to create page: 0.229 seconds