*** Restricting New Posts to SD Premium Members ONLY *** (09 May 2025)

Just made a new account? Can't post? Click above.

Help us help you. By posting the year, make, model and engine near the beginning of your help request, followed by the symptoms (no start, high idle, misfire etc.) Along with any prevalent Diagnostic Trouble Codes, aka DTCs, other forum members will be able to help you get to a solution more quickly and easily!

how to get a 2017 ford escape 4wd 2 litre into maintence mode

  • willing to learn
  • willing to learn's Avatar Topic Author
  • Offline
  • New Member
  • New Member
More
1 year 4 months ago #65950 by willing to learn
how to get a 2017 ford escape 4wd 2 litre into maintence mode was created by willing to learn
i have a 2017 ford escape 2 litre 4wd  i have to replace rotrs and pads was wondering how to put the epb into maintence mode 

Please Log in or Create an account to join the conversation.

  • Noah
  • Noah's Avatar
  • Offline
  • Moderator
  • Moderator
  • Give code definitions with numbers!
More
1 year 4 months ago - 1 year 4 months ago #65952 by Noah
Replied by Noah on topic how to get a 2017 ford escape 4wd 2 litre into maintence mode
1) Ignition switch ON
2) Press and hold gas pedal, and park brake switch in release (down)
3) While still holding gas pedal and park brake switch, turn ignition to OFF and then ON within 5 sec.
You should hear the caliper motors start working and message on the dash indicating service mode is active. You can then release the pedal and park brake switch and turn off the ignition.
To exit service mode, the process is the same except you must pull up on the park brake switch while performing the steps.
"Ground cannot be checked with a 10mm socket"
Last edit: 1 year 4 months ago by Noah.

Please Log in or Create an account to join the conversation.

Time to create page: 0.263 seconds