A place to discuss hardware/software and diagnostic procedures
DIY Secondary Ignition Multi probe.
4 years 11 months ago #29967
by Sooknanan
DIY Secondary Ignition Multi probe. was created by Sooknanan
Vehicle under test, Nissan teana 2010 with a 2.5 v6.
I made two multi probes approx. 12 inches long made with brass strips 5/8 wide by 1/8 thickness. The Brass strip was wrapped with electrical tape and a lead connected to a female banana jack for connection to the scope.
Video I followed for my build.
The vehicle had a misfire under load, car was placed in drive, break pedal depressed and the miss showed up intermittently. Very surprised how this turned out.
I made two multi probes approx. 12 inches long made with brass strips 5/8 wide by 1/8 thickness. The Brass strip was wrapped with electrical tape and a lead connected to a female banana jack for connection to the scope.
Video I followed for my build.
The vehicle had a misfire under load, car was placed in drive, break pedal depressed and the miss showed up intermittently. Very surprised how this turned out.
Please Log in or Create an account to join the conversation.
Time to create page: 0.224 seconds