It's been a while since I posted here - I've started a new job at a big factory, as an auto electrician, but I'm looking after the electric forklifts and
picking robots
Since I no longer have access to the Atis scope from the old job I've decided to force myself to like the Hantek 6022BE that I bought a while and used with my tablet for a while. Using it with the tablet is not very reliable due to all the connections so I am using it with a laptop and the original Hantek software.
Something I really liked about the Atis scope was the ability to set it for something like 20 seconds and record the pattern while actually watching the pattern slowly moving across the screen, then you could pause it as you like.
So far with the Hantek software I only seem to be able to change the time/volt divisions and then I have to wait until it has done a full cycle before the screen refreshes. I'm hoping someone can tell me a way to set it up like the Atis software with the "live view" recorder scope.
Getting involved in discussions because I have a lot to learn still.