Welcome to the Free YouTube Video Page!

Welcome to the ScannerDanner Free YouTube video page! We have YouTube videos from the beginning to September 2012 and January 2016 till now. We will be filling in the missing videos as time goes on. Please check back often!

In this part 1 of 2 series, I will show you how to test for play and replace a front axle u-joint. This job did not go as smoothly as I would have liked, but I left my struggles and mistakes in to help you guys better.

Add a comment

A common problem with these EVAP vent valves is a broken wire inside of the insulation! The wiring will look completely fine until you pull on the harness. In this video I will show you how to troubleshoot and repair this condition.

Add a comment

The pressure switch can be replaced independent of the fresh water pump and is a common failure item. How to replace just the pressure switch, as well as internals of the old switch, are shown.

Add a comment

Over 70 mph vibration during acceleration only, caused by tapered rear lift blocks. The fix was to use straight cut blocks. Below is information on the kit I used as well as other tools and related videos.

Add a comment

Join me and my son Beau as we troubleshoot a low water pressure problem (2001 American Tradition RV) when running off of the fresh water holding tank, using the electric water pump.

Add a comment

How to troubleshoot a no fuel pressure problem on any car. Is it the fuel pump, relay or wiring? Computer problem? Cam or Crank sensor problem? These questions and many others I will answer in this video.

Add a comment

This is a 2011 Ford Fusion with a P0455 (EVAP) System Leak Detected (Gross Leak/No Flow) trouble code. In this video I will show you how to test the EVAP purge solenoid, both mechanically and electrically. All that is needed is a generic scan tool and a test light.

Add a comment