Welcome to the Free YouTube Video Page!

Welcome to the ScannerDanner Free YouTube video page! We have YouTube videos from the beginning to September 2012 and January 2016 till now. We will be filling in the missing videos as time goes on. Please check back often!

I will show you how to troubleshoot the entire ignition system, including cam and crank signals, ECU to igniter control and igniter to ignition coil control using a simple test light. A follow up test will be done with a small single channel lab scope, showing yet another way to verify the same condition.

Add a comment

In this video I will show you how to replace the fuel filter on a 2001 Cummins 8.3L ISC engine. I will be following manufacturer recommended procedures and will be using factory recommended parts. (see Read More)

Add a comment

In this part 3 of 3 video I will show you how to properly recharge an A/C system using a set of manifold gauges and small cans of R134a refrigerant The tools I am using can be found further down in the description of this video.

Add a comment

1. The hardest part about this job was locating the correct parts. (see below).

Add a comment

In this part 2 of 3 series I'll be showing the following: how to install and test a used compressor using compressed air, R&R of condenser and lines, adding refrigerant oil and evacuation. I also install a new cooling fan shroud.

Add a comment

Soap and Water, an air compressor and manifold gauges are all you will need to find 95% of the leaks in an A/C system. The vehicle being used for this video is a 1995 Jeep Cherokee but the tests shown can be applied to any AC system.

Add a comment

In this video I will show you standard procedures I use to test the EVAP Purge and Vent Solenoids as well as leak tests that can be applied to any car, not just Nissan. I will be using a smoke machine to aid in my diagnosis (see link below on where to get one).

Add a comment